Enrichment with the Morin Ligand of Titanium Element from Waste Ash in Galvanising Factories
Şu kitabın bölümü: Gürbüz, F. (ed.) 2023. Matematik ve Fen Alanlarında Akademik Araştırmalar .

Buse Dağcı İsmailler
Kırklareli Üniversitesi
Cemile Özcan
Kırklareli Üniversitesi

Özet

In this study, it is aimed to determine the amount of Ti(titanium) in waste ash samples taken from galvanizing factories by using flame atomic absorption (FAAS). In addition, in these wastes, zinc (Zn), silicon (Si), nickel (Ni), manganese (Mn), iron (Fe), chromium (Cr), cadmium (Cd), aluminum (Al), lead (Pb) elements are also the method is intended to be determined.

Different solvent mixtures were tried to prepare the ash samples for analysis and SAE device was used at this stage. Morine ligand and Triton X-100 as surfactant was used for the recovery of Ti. The optimum results found were applied on ash samples. As a result of the study, while the optimum recovery values varied between 96-99% , the relative standard deviation values were found to be less than 10%. The enrichment factor and the recovery value in real samples were found to be 45 and 83%, respectively.

Kaynakça Gösterimi

Dağcı İsmailler, B. & Özcan, C. (2023). Enrichment with the Morin Ligand of Titanium Element from Waste Ash in Galvanising Factories . In: Gürbüz, F. (ed.), Matematik ve Fen Alanlarında Akademik Araştırmalar . Özgür Yayınları. DOI: https://doi.org/10.58830/ozgur.pub132.c582

Lisans

Creative Commons License

Bu çalışma Creative Commons Attribution 4.0 International License ile lisanslanmıştır.

Yayın Tarihi

22 June 2023

DOI